top of page
HiPP UK Stage 1
What You'll Need :
- Boiled Water
- Sterilized Bottles
- Teat & Cap
- Formula Powder
- Measuring Spoon (found in your formula box)
Steps :
1. Wash hands & sterilize all equipment following the bottle's manufacturer's instructions.
2. Boil 1 litre of freshly run water & leave to cool for no longer than 30 minutes.
Do not use artificially softened or repeatedly boiled water.
3. Measure the required amount of water into a sterilized bottle (referring to the feeding guide below).
4. Using the scoop provided, add the correct number of scoops of powder (1 level scoop of power to each
fluid ounce of water, approximately 30 millilitres).
Level off the powder using the scoop leveller (do not press the powder).
5. Place sterilized teat & cap on the bottle & shake well until all the powder has dissolved (approximately 15 seconds).
6. Cool to drinking temperature (approximately 37 Degrees Celsius) by holding the bottle under cold running
water, & feed immediately.
Always test the temperature of the milk before feeding.
Feeding Guide:
HiPP UK Stage 2
What You'll Need :
- Boiled Water
- Sterilized Bottles
- Teat & Cap
- Formula Powder
- Measuring Spoon (found in your formula box)
Steps :
1. Wash hands & sterilize all equipment following the bottle's manufacturer's instructions.
2. Boil 1 litre of freshly run water & leave to cool for no longer than 30 minutes.
Do not use artificially softened or repeatedly boiled water.
3. Measure the required amount of water into a sterilized bottle (referring to the feeding guide below).
4. Using the scoop provided, add the correct number of scoops of powder (1 level scoop of power to each
fluid ounce of water, approximately 30 millilitres).
Level off the powder using the scoop leveller (do not press the powder).
5. Place sterilized teat & cap on the bottle & shake well until all the powder has dissolved (approximately 15 seconds).
6. Cool to drinking temperature (approximately 37 Degrees Celsius) by holding the bottle under cold running
water, & feed immediately.
Always test the temperature of the milk before feeding.
Feeding Guide:
HiPP UK Stage 3
What You'll Need :
- Boiled Water
- Sterilized Bottles
- Teat & Cap
- Formula Powder
- Measuring Spoon (found in your formula box)
Steps :
1. Wash hands & sterilize all equipment following the bottle's manufacturer's instructions.
2. Boil 1 litre of freshly run water & leave to cool for no longer than 30 minutes.
Do not use artificially softened or repeatedly boiled water.
3. Measure the required amount of water into a sterilized bottle (referring to the feeding guide below).
4. Using the scoop provided, add the correct number of scoops of powder (1 level scoop of power to each
fluid ounce of water, approximately 30 millilitres).
Level off the powder using the scoop leveller (do not press the powder).
5. Place sterilized teat & cap on the bottle & shake well until all the powder has dissolved (approximately 15
seconds).
6. Cool to drinking temperature (approximately 37 Degrees Celsius) by holding the bottle under cold running
water, & feed immediately.
Always test the temperature of the milk before feeding.
Feeding Guide:
HiPP UK Anti-Reflux
What You'll Need :
- Boiled Water
- Sterilized Bottles
- Teat & Cap
- Formula Powder
- Measuring Spoon (found in your formula box)
Steps :
1. Wash hands & sterilize all equipment following the bottle's manufacturer's instructions.
2. Boil 1 litre of freshly run water & leave to cool for no longer than 30 minutes.
Do not use artificially softened or repeatedly boiled water.
3. Measure the required amount of water into a sterilized bottle (referring to the feeding guide below).
4. Using the scoop provided, add the correct number of scoops of powder (1 level scoop of power to each
fluid ounce of water, approximately 30 millilitres).
Level off the powder using the scoop leveller (do not press the powder).
5. Place the sterilized teat and cap on the bottle and roll between the palms for 5 seconds.
Shake for 20 seconds, then leave to stand for 7 minutes to thicken.
6. Shake again, then check that the milk is at feeding temperature (approximately 37 Degrees Celsius).
Feed immediately.
Always test the temperature of the milk before feeding.
Feeding Guide:
HiPP UK Ready to Feed Stage 1
What You'll Need :
- A bottle of HiPP Ready to Feed Stage 1
- Sterilized Bottle
- Teat & Cap
Steps :
1. Wash hands & sterilize all equipment following the bottle's manufacturer's instructions.
2. Check expiration date.
3. Remove the plastic lid and gently squeeze the bottle to make sure the foil is intact.
4. Shake bottle well.
5. Pour required amount of milk into the sterilized feeding bottle.
HiPP UK Ready to Feed Stage 1 can be given at room temperature or warmed if desired.
6. For hygiene reasons, discard unfinished milk in feeding bottle as soon as possible and always consume within 2 hours.
Feeding Guide:
HiPP UK Ready to Feed Stage 2
What You'll Need :
- A bottle of HiPP Ready to Feed Stage 2
- Sterilized Bottle
- Teat & Cap
Steps :
1. Wash hands & sterilize all equipment following the bottle's manufacturer's instructions.
2. Check expiration date.
3. Remove the plastic lid and gently squeeze the bottle to make sure the foil is intact.
4. Shake bottle well.
5. Pour required amount of milk into the sterilized feeding bottle.
HiPP UK Ready to Feed Stage 2 can be given at room temperature or warmed if desired.
6. For hygiene reasons, discard unfinished milk in feeding bottle as soon as possible and always consume within 2 hours.
Feeding Guide:
Babies from 6 months onwards need about 500ml to 600ml of HiPP Organic follow-on milk per day, either as a drink, on cereal or added to other foods. However, this is only a guide, so your baby may need more or less than this.
If you would like more advice, please check with your health professional.
HiPP UK Ready to Feed Stage 3
What You'll Need :
- A bottle of HiPP Ready to Feed Stage 3
- Sterilized Bottle
- Teat & Cap
Steps :
1. Wash hands & sterilize all equipment following the bottle's manufacturer's instructions.
2. Check expiration date.
3. Remove the plastic lid and gently squeeze the bottle to make sure the foil is intact.
4. Shake bottle well.
5. Pour required amount of milk into the sterilized feeding bottle.
HiPP UK Ready to Feed Stage 3 can be given at room temperature or warmed if desired.
6. For hygiene reasons, discard unfinished milk in feeding bottle as soon as possible and always consume within 2 hours.
Feeding Guide:
Toddlers from 1 years old need about 350ml of HiPP Organic Growing up milk per day, either as a drink, on cereal or added to their food. However, this is only a guide and your toddle may need more or less than this.
If you would like more advice, please check with your health professional.
HiPP GER Hypoallergenic/HA
Ready to Feed Stage Pre
What You'll Need :
- A bottle of HiPP GER Hypoallergenic Ready to Feed Stage Pre
- Sterilized Bottle
- Teat & Cap
Steps :
1. Thoroughly clean the bottle, teat and ring.
​
2. Check the closure for perfect condition before use.
​
3. Shake the still sealed bottle before opening it for the first time.
​
4. Fill the required amount of drink into a bottle and warm to drinking temperature.
​
5. Do not heat the food in the microwave (risk of scalding).
​
6. Check temperature again before feeding.
​
7. Feed food immediately and do not reuse leftovers.
Feeding Guide:
SHOP
ACCOUNT
-
-
COMPANY
FOLLOW & CONTACT US
-
-
© 2020 All Right Reserved by Organic Bum
bottom of page